2 pin LED Signal Flasher Module Relay w/ Ground!

This is a 12V electronic signal flasher (blinker) module relay that is a plug and play design.  This relay is designed to fix "no flash" or "hyper flash" problems that often result after installing LED bulbs as turn signal lights.  This is designed for vehicles with LED bulbs installed in the lights in some or all of the turn signals locations.  We caution the use of this in towing vehicles where a high number of incandescent bulbs in the vehicle and trailer are controlled by the vehicles turn signal system, as maximum the capacity of this unit is a 20A load.  Exceeding a 20A load will damage this unit.  If your vehicle does not have any LED bulbs in the turn signal circuit, you may also consider our 12V Electronic Signal Flasher Relay, which is designed for full incandescent or combination systems with mostly incandescent bulbs in the turn signal circuit.   

This flasher has a ground wire that allows the flasher to sequence even when the load would be invisible to other flashers.  Simply ground the wire to your chassis and plug the flasher into the stock flasher location.  There are no other modifications required to use this flasher in most vehicles.  These high quality electronic flashers are designed to replace standard two terminal flasher relays and operate at the normal DOT blink rate for motor vehicles with stock LED bulbs installed. If you are upgrading to LED turn signal lights, this is a must have item.

We only carry this in the common 2-pin design.  Please verify the correct flasher type for your vehicle before purchasing.  Some vehicles may require two flasher relays, one for the turn signals and one for the hazard lamps.